19 May 2021. Observation on the Schumann Resonances, from Tomsk S.O.S. Midnight Peaks.
Peak at 3 AM, local time. The small white numbers under the spectrogram are the local time readings.
UTC is 17 Hours ahead of local time at Tomsk. East Coast USA is 5 hours behind UTC. Therefore, my time in East coast is 22 Hours behind Tomsk readings.
At 12 hours away, I am exactly opposite the geographical location there. Essentially, I'm the other side of the globe, in East coast US, from Tomsk Russia. That freakish burst would have been during my daytime.
_
Keep in mind, the antenna-detector units have a limited operational range. Even though the Schumann resonances do travel around the world, this is in the magnetic-side of the signal, and not as an amplitude wave.
Schumann resonances are primarily caused by lightning discharges, which start to vibrate as frequency (a wave), that bounces between the ionosphere and the Earth's surface. These are very subtle energies, in the pico-Tesla range.
Many people focus on the Amplitude spikes as the most important aspect of Schumann-resonances, ignoring the actual resonances themself, in place of the sexy-narrative version of the phenomena.
Earth's natural Telluric power (the heartbeat function) is measured in the nano-range. The Geo-electric power grid of the Earth is a certain strength, again as nano-Tesla strength. Schumann resonances are subtle; around 1,000 times weaker than Earth's natural field.
My assessment is that the Schumann resonances are not that strong to be causing alot of the maladies that folks want to put at the feet of the atmospheric "humming". The atmosphere itself may be buzzing with the Schumann-series, but Earth is BELLOWING!
Amplitude bursts released by seismic activity is an interruption of Earth's natural telluric (lower 'DC' circuit) power flow. Amplitude burst from seismic activity is localized. One can not, in good conscience look at the readings from Cumiana, for example, and apply them to your geographical location.
Amplitude is the height, or Intensity of the signal. This is measured in deci-Bels. Amplitude is not a frequency number. Amplitude is a velocity (straight line), not a wave. Amplitude is charge, which is (+/-); the voltage of the signal.
Amplitude is released from lightning discharges, which flash, then degrade into magnetics. Amplitude is essentially the rapid release of charge from ionosphere, or cloud, into the Earth ground circuit. The upper-atmosphere is one pole of the geoelectric circuit battery; with the Earth ground itself as the other pole.
The lower atmosphere, the air that we breath, generally acts as a fine-enough insulator between these two poles/polarity. Multiple factors effect the balance of this system, and force electricity from the high charge of the voltage of the upper atmosphere, down into the lower realms of the Earth ground circuit.
The bulk of Schumann resonances is the magnetic frequencies which travel around the world as the Quality you would see on the dependency report.
These Quality waves [frequency is peak-to-peak measurement, in kilometers] are magnetic flux/fluxuations, or movement. Magnetics are current, which move in a direction. These Quality waves are what bash-together, to form the resonances of the atmospheric harmonics of the Schumann-series.
web link: (https://www.schumann-resonances.com/post/19-may-2021-observation-on-the-schumann-resonances-from-tomsk-s-o-s-midnight-peaks)
** ** ** **
How To Read The Schumann resonance Spectrograph ["The Schumann"] Properly.
Basic Introduction
The Spectroscope is the full-color visual representation of the Schumann resonances. It is a composite, which is plotted in full-colour, based upon the infortmation recieved from the reporting dependencies. It is this fun, yet quixotic 'visual aid', is most often used alone, without the necessary reporting dependencies, which ultimately give it the meaning. It is this solitary portion of the SR reports, which just-about-everyone who is using this, calls "The Schumann."
The Schumann resonances (SR) are a set of spectrum peaks in the extremely low frequency (ELF) portion of the Earth's electromagnetic field spectrum. Schumann resonances are global electromagnetic resonances, generated and excited by lightning discharges in the cavity formed by the Earth's surface and the ionosphere.
The purpose of this essay is to assist people who are interested in this subject, to better understand what they are actually looking-at when they view the plotted Spectrographic composite, colloquially called "The Schumann."
(Note:*When I do my readings for the day, I explain the interaction of the dependencies of Amplitude, Quality, and Frequency independently of the effect on the composite spectrograph. I mainly focus upon the interaction between these three factors, which is ultimately how and why we get the interesting patterns that we do. It's our opinion that one can not truly know the meaning of these patterns nor Codes, if one is oblivious to how these patterns get produced, then reported.)
Orientation.
We start with an overview. On the left side of the graph is the resonance frequency, which starts at 0 in the top left corner. From there moving downwards, the numbers increase.
Running along the bottom of the graph is the measurement of Time. There are two sets of clocks. The larger, bottom numbers are UTC. Above this is local time.
The Spectrograph is plotted from the reporting 12 dependencies, of Amplitude (Modes 1-4) ; Quality (Modes 1-4) ; Frequency (Modes 1-4); upon the Dark Blue coloured "canvas."
Dark blue would be our theoretical "at rest state." (Which we theoretically return back to. It might be considered like an "elastic", or a medium which is under a certain tension, therefore always in motion to or from that dark blue background "at rest", or balance point.) Upon this the twelve dependencies use actual light to plot a tapestry of patterns and codes. Because the atmosphere, which includes all the way out into the magnetosphere, is elastic in this sense, this is what essentially creates this "weaving" pattern of sheparding these EM waves around the "waveguide" of the Earth-Ionosphere 'corridor.'
At rest state of "fair weather", is our theoretical "zero point"; which starts as a dark blue (Navy)-coloured background, which is as above-stated an interactive canvas. Upon this canvas gets reported with, or plotted by the information of the dependencies. This is the actual raw data which is graphed by the line graphs of 4 individual colours. I am referring to these 4 colours, which correspond to the 4 modes, as our pallet of "primary colours." (Technically, White is not a colour, but blue is. We essentially have 4 colours as our primary pallet.)
When the literature refers to Modes, this relates to the type of internal copper windings (based upon the number of turns, of the size and cross section of wire, etc.), which allow for a certain known range of signals to be detected. This band of signalsis in the lowest end of low frequency radio waves, which encircle the globe; primarily due to lightning discharges.
Introducing The Antenna
On the subject of the receiving antennas for the data, I have posted many times in The Schumann Resonances harmonics group highlighting the technology and workings of the antennae used to collect the data. For our purposes here, we need to understand a few basic concepts on how the signals are measured.
There are a few different type of antennae designs, yet the principle remain consistent, based on the following principle: The Electric portion of the signal transverses, rolls, or propagates vertically; while the magnetic portion of the signal travells horizontally, which is to say "hugging the ground."
Generally there is a ball on a "tower" which measures the Amplitude, or the electric portion. This is a dipole antenna for measuring the Amplitude.
Each antenna Mode reports: Amplitude, Quality, Frequency. The antenna is recording a 3 dimensional configuration This is set-upon the base which measures the magnetics, or Quality, along two separate axes, 90 degrees apart; these are North-South / East-West.
The heart of the antennae is the induction coil which is wrapped around a magnetically permeable material. The coil senses a EMF signal which is within the range of receptivity, based upon the structure of the internal windings. The signal activates, initiates "movement" along the coil, producing a "report", or a line in the reporting dependency.
Essentially, there are 2 induction magnets: for N-S, and one for E-W. . The spectrograph is showing a 3 dimensional, spherical, construction, on a plane surface.
The ELF frequency range, as stated by Volland in Handbook of atmospheric electrodynamics, 1995, covers a frequency range from 3-60 hertz. A Hertz is a unit of frequency, which is measuring peak-to-peak amount within the time period of one second. As the frequency, wave to wave height increases, the length decreases inversely.
The Twelve Dependencies: 4 Modes Of Reception.
A Mode is essentially a "band", or bandwidth of measurement, within the EMF spectrum. In this case, ELF is broken-up into 4 segments, or modes. It is a mathematical description of a size and shape of a wave form.
This next section explaining the use of the Modes is difficult without numbers and specific technical data. I'm working to best give pictures of the process. We see the Modes as bandwidths, separations (similar to octaves) of the entire spectrum. In otherwords, it is the means of breaking-down the entire spectrum of EMF waves, which span a wide range of ELF radio waves
White is Mode 1. This correlates to the highest layer of the ionosphere, furthest away from the planet. Highest frequency, of the low-range energy where the resonances reside.
Yellow is Mode 2, which measures a lower frequency range, or bandwith, than the White Mode.
Red is Mode 3, which measures successively lower range of bandwith than Yellow.
Green is Mode 4, the lowest frequency, but largest in wavelength, between 10-100,000 Km in wavelength sizes.
Plotting The Spectrograph
Due to the abilities of the antennae to pick-up only certain signals, these colours are going to also appear in certain recognizable patterns, based-upon the type of signal; whether it is more electric, or more magnetic. For example, the bright green shows up largely as bands, due to the fact that it is exhibiting the characteristics of the magnetic waves.
Depending on where and how the EMF signal interacts with the antennae, this is the type of mark which is going to be plotted on the spectrograph, effectively.
In other words, white, and yellow frequently, appear as spikes, or vertical lines, due to the high content of electric charge, and the fact that this is how the antennae pick-up Amplitude/charge/electrics. White and Yellow Modes are more heavy in electric content.
Red and Green modes measure the layers closer to Earth. Green Measures the layer of emf waves which occupy the space between Earth and the lowest layer of the ionosphere. Ultimately, the ilonosphere acts as a filter of sorts, which forces the bouncing, or return characteristics of the wavious wavelengths are.
Because the Green is high in magnetic content, the green-based colours are going to be magnetic, and display horizontally, to reflect the orientation of the reporting dependencies, Quality. We see an "upright", or vertical signal in Quality in the line graph, but the full color spectrograph shows it much better, the orientation of the magnetics, basically as "flat."
The colours teal, aqua, turquois, "indiglow" are not actually in the "Green family", dispite what your colour theory may tell you. They are...but not really. These are a product of the interaction with the background of Modes 1, and 2, the white and yellow.
White and yellow is top going down, as it were, into the otherwise calm background state of rest of the Dark Blue.
Going upwards from rest into the bottom of the modes, due to heavy magnetics, the colouration goes from dark blue into Green. This is how we know that the bright teal and turquoise is a signal moving from top (high charge), downwards into the "at rest state."
Red and Yellow make orange, pumpkin, rust,; when mixed with white we get coral, or pink. These indicate a mid-grade electronics, fairly balanced with magnetics. This is why orange and rust colours seem to "float in the air" of the chart, because it is actually "floating" somewhat.
* ** *** **** *** ** *
Comments